The DM706M1 is an E1 multiplexer with two E1 (G.703/G.704) interfaces, and one 2W G.SHDSL.bis (G.991.2) interface and an Ethernet (10/100BaseT) interface that can work as a router and several software functionalities, including user remote authentication (RADIUS and TACACS), Firewall, NAT, VPN and QoS. Offers housing for an expansion card that can activate 4 to 8 FXS ports.
The DM706M1 is an E1 multiplexer that allows voice and data transference at up to 5.696kbit/s.
The DM706M1 features two E1(G.703/G.704) interfaces, one 2W G.SHDSL.bis (G.991.2) interface and one Ethernet (10/100BaseT) interface that can work as a router.
The G.shdsl port can operate at up to 5,696kbit/s, in compliance with ITU-T G.991.2 rev2.
Allows the aggregate’s 64 kbit/s to be distributed among all tributary simultaneously, allowing both voice and data to be broadcast by the same equipment through different interfaces;
It performs all the routing tasks by means of a WAN interface, where it receives incoming data from the E1 aggregate or DSL card and performs routing of this traffic to the Ethernet port.
Desktop modem (195x200x44mm), with 93-250VAC or 36-72VDC automatic power supply.
The Router interface features several software functionalities. Notably along them are the routing functions, remote user authentication (RADIUS and TACACS), network security (firewall), address and port translation (NAT ), safe connections (VPN), packet tagging and prioritizing (QoS).
Remote management via HDLC (via E1-A) or EOC (via DSL), depending on the aggregate settings. All functionalities can be managed through the DmView management platform when the DM706M1 is the DM705-SUB multiplexor remote device.
Operation with internal or regenerated clock through E1 ports or G.shdsl port. Automatic commuting to the internal clock in the absence of the regenerated clock.
Test pattern generator with error detection, activated by the control port (BERT).
Indicative LEDs for power supply, test, E1, DSL, FXS and router (SYS, WAN and ETH) interface status.
The device sends a switch-off by power surge notification through the G.shdsl frame power status bit, when configured to NTU. That indication can be seen through the Remote Power Fail alarm in the DM705-SUB, when connected to the DM706M1 through a DM705-DSL8 card.
- The DM706M1 aggregate interface can be both the G.shdsl port and the E1-A port. When the G.shdsl link is used as an aggregate, both E1 ports can be used as tributary. When the E1-A port is used as an aggregate, the G.shdsl link becomes unavailable.
- As an expansion card, other interfaces can be installed, including 4-8-channel FXS 2W voice cards.
- It is entirely configurable via terminal emulation with a DB9 RS232 control port on the front panel.
- It is entirely configurable via Telnet or SSH, featuring a physical connection with a LAN or WAN Router port.
- Possible synchrony sources: internal or regenerated clock through E1 ports or G.shdsl port.